Download  Print this page

Throttle Cable Lubrication; Throttle Cable Inspection - Kawasaki KX250F Service Manual

Hide thumbs

Advertisement

Table of Contents
Throttle Grip and Cable
Remove the rear frame assy (see Frame chapter).
Remove the carburetor and move it to the right side of the
frame.
Unscrew the bolt [A].
Remove the throttle pulley cover [B].
Loosen the locknuts [A].
Remove the cables [B] from the carburetor.
Free the tips [C] from the pulley.
Pull out the cables from the frame.
Lubricate the cable.
Apply grease to the tips of the cables.
Install the throttle cable lower end as shown.
Turn out the locknut [A] fully.
Install the cable tips [B].
Set the outer cable ends [C] to the holder.
Turn the adjuster [D] until the cable is extend.
Install the throttle pulley cover.
Torque - Throttle Cable Locknut: 7.0 N·m (0.7 kgf·m, 61
ft·lb)
Throttle Pulley Cover Bolt: 3.4 N·m (0.3 kgf·m, 30
in·lb)
Install the throttle cable in accordance with the Cable,
Wire, and Hose Routing section in the Appendix chapter.
After the installation, adjust each cable properly.
Operation with an incorrectly routed or improperly
adjusted cable could result in an unsafe riding con-
dition.

Throttle Cable Lubrication

Whenever the throttle cable is removed or in accordance
with the Periodic Maintenance Chart, lubricate the these
cables, Refer to General Lubrication in the Periodic Main-
tenance Chapter.
Apply a thin coating of grease to the cable upper or lower
ends.
Use a commercially available pressure cable lubricator to
lubricate these cables.

Throttle Cable Inspection

Refer to the Cable Inspection in the Periodic Maintenance
chapter.
WARNING
http://manuals.magnamaniac.com
FUEL SYSTEM 3-9

Advertisement

Table of Contents

   Also See for Kawasaki KX250F

Comments to this Manuals

Symbols: 0
Latest comments: