The ULTRA WASH soil removal system gives you sparkling clean
dishes, while using less energy and time. The ULTRA WASH soil
removal system includes:
A heavy-duty grinder that acts as a food disposer to grind and
dispose of large food particles.
How the ULTRA WASH soil removal system works
Load the dishwasher. Remove bones, large chunks or
food. No rinsing is necessary. Any remaining food
soil will be ground up and disposed down the drain with the
Hot water fils the dishwasher to a level near the bottom of
the overfill protection float.
3. The HEATING indicator glows and the dishwasher pauses
while the water is heated.
4. When the water reaches the proper temperature,
HEATING indicator turns off and the cycle countdown
Detergent from the detergent dispenser is dispensed at the
correct cycle times and hot water is pumped through the
ULTRA WASH pump.
Hot water and detergent sprays against the soiled surfaces of
the load and removes food particles.
Food soil is held in an accumulating
Before using your dishwasher, remove all packaging
Read this entire Use and Care Guide. You will find important
and useful operating tips.
1. Scrape large food soil and hard items (toothpicks or bones)
Properly load the dishwasher. (See "Dishwasher Loading.")
Make sure nothing prevents the spray arm(s) from spinning
3. Add detergent and check the rinse aid dispenser. Add rinse
aid if needed. (See "Dishwasher Use.")
Food soil is disposed down the drain with the wash water.
Fresh, hot water enters the dishwasher and sprays on the
dishes. The rinse water is then pumped through the
ULTRA WASH soil removal system and remaining soil
10. The food soil that is held in the ULTRA WASH soil removal
system is disposed down the drain with the rinse water.
11. The final rinse water is heated. The rinse aid is added to the
water for the final rinse to prepare the dishes for drying.
Push door firmly closed. The door latches automatically.
hot water at the sink nearest your dishwasher
until the water
is hot. (See "Dishwasher Efficiency Tips.") Turn off water.
Press the desired cycle and option selections. (See
Use.") Turn the Cycle Control knob to the
desired cycle to start.