Use the Lock On to prevent unintended use of the dishwasher
When Lock On is lit, all buttons are disabled.
NOTE: The dishwasher door can be opened while the controls
To turn on the Lock
Press and hold HEATED DRY for 4 seconds. Lock On glows.
If you press any pad while your dishwasher is locked, the light
flashes 3 times.
NOTE: If the Heated Dry option is selected, the light will
temporarily turn off until Lock On glows.
To turn off the Lock
Press and hold HEATED DRY for 4 seconds. The light turns off.
4 Hr Delay
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay. After adding items, press START/RESUME. Make sure the
door is latched or the delay will not continue.
To delay the start
1. Press the delay button to choose the number of hours
2. Select a wash cycle and options.
3. Press START/RESUME.
The dishwasher starts the cycle in the selected number of hours.
To cancel the delay and cycle, press CANCEL/DRAIN.
To cancel the delay and start the cycle, press START/
Cycle Status Indicators
Follow the progress of your dishwasher with the Cycle Status
Clean glows when a cycle is finished. The light turns off when you
press any button or close the door.
If you select the Sani Rinse option, Sanitized glows when the
Sani Rinse cycle is finished. If your dishwasher did not properly
sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle is interrupted or the incoming water
temperature is too low. The light turns off when you press any
button or close the door.
The active vent reduces the filling and washing sounds from your
dishwasher. The vent closes, after the cycle starts, to lock in
sound. After the cycle finishes and the dishes cool for several
hours, the vent opens. This keeps any water vapor from
collecting on the countertop. Between cycles, the vent stays
open for airflow, reducing the buildup of odors.
NOTE: There is a slight noise when the vent closes or opens. This
Overfill Protection Float
The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.