How It Works
1 Dehumidifier must be operated in an enclosed area to be most effective, Close
all doors, windows, and other outside openings to the room.
2, Be sure not to obstruct the air flow through the front grille or out of the louvers
on the left side,
A dehumidifier operating in a basement will have little or no effect in drying an
adjacent enclosed storage area, such as a closet, unless there is adequate
circulation of air in and out of the area.. It may be necessary to install a second
dehumidifier in the enclosed area for satisfactory drying.
When the unit is started, the fan begins to pull moisture-laden air across the
dehumidifying coils The coils condense or draw moisture from the air, and air flows
through the side louvers into the room as dry, warm air. Moisture removed from air
is collected in a bucket on the front of the dehumidifier,,
NOTE: This unit is equipped with Electronic Control Protection. There is a 2 minute
delayed start after one of the following occurs:
The bucket is removed
Dehumidifier Level changes
To begin operating
I Plug the power cord into a properly grounded 1101120 volt AC outlet
Note: Before operating this unit, see the "Removing Collected Water" section
for proper placement of the bucket Models will not operate if the bucket is not
2. When first using the dehumidifier, set the control to the MAX.DRY position The
unit will run continuously at this setting
Note: The dehumidifier should be kept in operation as long as excess moisture
is present in the room air
3. Set Fan Speed to HI. The HI setting is recommended for faster moisture removal
4. Allow the dehumidifier to operate at the above settings for three to four days.
After this time, adjust the controls as needed See below.
DEGREE O F
DEGREE O F
ili!!iil B UCKET
Please familiarize yourself with the Control Panel before you begin Your Dehumidifier can be operated from 15% MAX to 75%
MIN Relative Humidity, at either High or Low Speed (except 5030),