Canon MG6600 Series Manual page 279

Note
• Signal strength is displayed as follows.
: Good
: Fair
: Poor
• Type of encryption is displayed as follows.
Blank: No encryption
WEP: WEP is set
WPA/WPA2: WPA/WPA2 is set
2. Refresh
Click to update the list of access points when your target access point is not detected.
If the target access point is set to a closed network (the stealth mode), click Cancel to return to the
previous screen and enter the network name (SSID) in Network (SSID).
Note
• Make sure that the access point is turned on.
3. Set
Click to set the network name (SSID) in Network (SSID): on the Wireless LAN sheet.
Note
• The WEP Details screen or the WPA/WPA2 Details screen appears if the selected access
point is encrypted. In this case, configure the details to use the same encryption settings set
to the access point.
• Access points that cannot be used by this machine (including those configured to use different
encryption methods) are displayed grayed out and cannot be configured.
279