Operating Instructions; Lighting And Operating Label - Kenmore THE ECONOMIZER 153.33204 Owner's Manual

OPERATING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
explosion may result causing property damage, personal injury
or loss of life.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
This appliance does not have a pilot. It is equipped with
A.
an ignitiion device which automatically lights the
burner. Do not try to light the burner by hand.
B.
BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch;
do not use any phone in your building.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
VACATION
WARM
COOLER
--------------
----------------------- ----------------------
------------------------------------------------------
* -----------------------------------------------------------------------
* ----------------------------------------------------------
--------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------
* ------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------
1. STOP! Read the safety information above
on this label.
2.
Set the ON/OFF switch on the control box to the
"ON" position.
Set the thermostat to the lowest setting by first
3.
pressing the COOLER
tons together and holding for 1 second. Then press
the COOLER button
light appears.
4. Set the ON/OFF switch on the control box to the
"OFF" position.
TO TURN OFF GAS TO APPLIANCE
Set the thermostat to the lowest setting by first
1.
pressing the COOLER
tons together and holding for 1 second. Then press
the COOLER button
light appears.
If you do not follow these instructions exactly, a fire or
OPERATING INSTRUCTIONS
A B C
VERY
HOT
HOTTER
------------------------------
and HOTTER but-
until the Warm indicator
and HOTTER but-
until the Warm indicator
23
If you cannot reach your gas supplier, call the
fire department.
Use only your hand to push in the gas control but-
C.
tons. Never use tools. If the control buttons will not
push in, don't try to repair them, call a qualified ser-
vice technician. Force or attempted repair may
result in a fire or explosion.
Do not use this appliance if any part has been
D.
under water. Immediately contact a qualified
installer or service agency to replace a flooded
water heater. Do not attempt to repair the unit.
It must be replaced!
5.
This appliance is equipped with a device
which automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
Wait five (5) minutes to
6.
If you then smell gas,
the safety information above on this label. If you
don't smell gas, go to the next step.
7.
Turn on all electrical power to the appliance.
8. Set the ON/OFF switch on the control box to the
"ON" postition.
9. Set the thermostat to the desired setting by first
pressing the COOLER
tons together and holding for 1 second. Then press
the HOTTER button
10. WATER TEMPERATURE ADJUSTMENT
o
approximately 120 F.
CAUTION: Hotter water increases the risk of
scald injury. Consult the instruction
manual before changing temperature.
11. If the appliance will not operate, follow the instruc-
tions "TO TURN OFF GAS TO APPLIANCE" and
call your technician or gas supplier.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING.
2. Set the ON/OFF switch on the control box to the
"OFF" postition.
3.
Turn off all electrical power to the appliance if
service is to be performed.
FLAMMABLE
clear out any gas.
STOP! Follow "B" in
and HOTTER but-
is