Electrical Requirements; Installing The Power Cord - Kenmore 580.75281 Owner's Manual

Kenmore air conditioner user manual
Hide thumbs Also See for 580.75281:
Table of Contents

Advertisement

Available languages

Available languages

OBSERVE
ALL LOCAL CODESAND ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,REMOVE
THE POWERSUPPLY CORD GROUND PRONG.
ELECTRICALGROUND IS REQUIREDON THIS
APPLIANCE.
For 230/208volt 60 Hz,AC only, 15A fused and
properlygrounded electricalsupply is required.A time
delay fuse or time delay circuit breaker is
recommended.Use a dedicated circuit, serving only
this appliance.
DO NOT USEAN EXTENSIONCORD.
RECOMMENDEDGROUNDINGMETHOD
Foryourpersonal s afety,this appliance mustbegrounded.
This appliance hasa powersupplycordwitha 3-prong
grounding plug.To minimizepossible shockhazard, t he
cordmustbe plugged intoa matinggrounding typewall
receptacle and grounded in accordance withthe National
Electrical C ode(ANSl/NFPA 70) latesteditionand all local
codesandordinances. I f a matingwall receptacle is not
available,it isthe personal r esponsibility a nd obligation of
the customer to havea properlygrounded 3-prongwall
receptacle installed bya qualifiedelectrician.
115V~
230V~
NOTE: The shape may be different according to its model.
Power cord may include a current interrupter
device. A test and reset button is provided on the
plug case. The device should be tested on a
periodic basis by first pressing the TEST button
and then the RESET button. If the TEST button
does not trip or if the RESET button will not stay
engaged, discontinue use of the air conditioner and
contact a qualified service technician.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
You can choose between two methods below according to your window sill shape and preference.
USING
SLIT "A"
Fasten the stopper using 2 screw holes, and lead
out the power cord through slit "A".
USING
SLIT "B"
Fasten the stopper using left screw hole, and rotate
properly to lead the power cord out through slit "B".
!
_
Power Cord
_
-4-

Advertisement

Chapters

Table of Contents
loading

Table of Contents