Download  Print this page

Installation; How To Install - Kenmore 580.75051 Owner's Manual

Kenmore air conditioner user manual.
Hide thumbs

Advertisement

INSTALLATION
Pick a locationwhich will allow you to blow the cold air into
the area you want. Windows usedfor installation must be
strong enough to supportthe weight of the air conditioner.
Good installationwith special attention to the proper position
of the unit will lessen the chance that servicewill be needed.
If air conditioner is blockedby a storm window frame, see
step 9 on page 7 before beginningto install.
HOW TO INSTALL
U
SIDE CURTAINS
Insert the side curtains into the upper and lower
guides of the air conditioner. Fasten the curtains to
the unit with screws (ITEM A), as shown in FIG. 2.
ITEMA
FIG. 2
_'_ FOAM STRIP
Cut the adhesive-backed foam strip (ITEM D) to the
window width.
Remove the backing from the foam strip and attach the
foam strip to the underside of the bottom window. (FIG. 3)
L_I ATTACH L BRACKET
• Install the L brackets on the outer sill with the short
side of the bracket against the back of the inner
sill. Install one L bracket 8" to each side of center
line. See FIG. 5.
• The bracket helps to hold unit securely in place.
Be sure to place bracket edge flush against back
of inner sill. See FIG. 5.
• If air conditioner is blocked by storm window
frame, see step 9.
INNER SILL
OUTER SILL
ITEM A
INSIDE
LINE
f
SHORT SIDE
OUTSIDE
L BRACKET
FIG. 5
DRAINAGE
First, be sure to insert the drain pipe into base pan
before installation.
The air conditioner must be installed with a slight tilt
downward (see FIG. 8) for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe.
FIG. 3
_'_ LOCATING UNIT IN WINDOW
Open the window and mark center line with pencil
on the center of the inner sill, as shown in FIG. 4.
INNER SILL
ROOM SIDE
FIG. 4
DRAINCAP
DRAINPIPE
_BASE
PAN REAR
DRAIN _,__
FIG. 6
-6-

Advertisement

Table of Contents

   Related Manuals for Kenmore 580.75051

Comments to this Manuals

Symbols: 0
Latest comments: