Appendix B
Maintaining the Router
Step 5
Reinstall the chassis on the wall, rack, desktop, or table.
Reconnect all cables. If the router uses a DC power supply, switch the circuit breaker to the ON position.
Step 6
Replacing the Chassis Cover on Cisco 2691
Place the chassis bottom so the front panel is closest to you.
Step 1
Hold the cover so the tabs at the rear of the cover are aligned with the chassis bottom.
Step 2
Push the cover toward the rear, making sure that the cover tabs fit under the chassis back panel, and the
Step 3
back panel tabs fit under the cover.
Slide the cover slightly to the left to lock the cover into position (See part 1 in
Figure B-17 Replacing the Cisco 2691 Router Cover
Lower the front of the cover onto the chassis (See part 2 in
Step 4
Fasten the cover with the five screws you set aside earlier.
Step 5
OL-2171-02
1
Figure
B-17).
Cisco 2600 Series Routers Hardware Installation Guide
Closing the Chassis
Figure
B-17).
2
B-35