Cisco 2600 Series Hardware Installation Manual page 100

Replacing the Boot ROM
Figure B-15 Removing the ROM from the System Board
Orient and insert the new ROM in its socket as shown in
Step 3
any of the bottom pins. To straighten out a bent pin, use needlenose pliers. Align the notch in the new
ROM with the notch in the ROM socket, ignoring the orientation of the label.
Figure B-16 Installing the ROM in the System Board
The notch on the ROM must match the notch on the socket on the card. Installing the ROM backward
Caution
will damage it.
Cisco 2600 Series Routers Hardware Installation Guide
B-32
Angled tips
Extraction slots
Align notches
on ROM
and socket
PLCC
extraction slot
ROM socket
ROM
Figure
Appendix B Maintaining the Router
PLCC extraction
tool
PLCC
extraction slot
B-16, being careful to not bend or crush
Press the
ROM into
place evenly
and firmly
OL-2171-02