Watts: 1250W Dust Capacity: 1.1L Noise Level: <84dBa Telescopic Tube: Chrome Power Cable Length: 5m Weight: 4.8kg Please contact Hoover Customer Care: 1300 360 845 to find your local spare parts provider. Part Part Number Dust Container 33151744 Filter Cone...
Before you begin The cleaner must be operated in accordance with these instructions and used only for domestic household cleaning to remove DRY dirt and dust from household carpets, flooring and fabrics. This cleaner is not fit to be used as an industrial cleaner, and is not designed for the collection of vitreous building material including particle board, construction products and similar products such as wood/fibres, cement, fillers, fibre glass etc or excessive or frequent sand.
Page 5
Precautionary measures: Do not operate the vacuum cleaner too close to heaters, radiators, and other hot surfaces. Before inserting the plug into the wall, make sure your hand is dry. Before turning on the vacuum cleaner, remove any large or sharp objects from the floor or cleaning surface in order to prevent damage to the filter.
Page 6
16. Ensure the appliance is disconnected from the mains power supply before connecting the hose to the unit. 18. If the power cable is damaged, return to a Hoover service agent or contact Hoover Customer Care in order to avoid a hazard.
Instructions for use Before using, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Do not extend the cable beyond the blue mark. 1.
Page 8
Instructions for use Always remove the plug from the power socket before fitting or removing accessories! Assembling the vacuum cleaner 1. Fitting or removing the hose To fit the hose, insert into the air intake duct at the front of the cleaner. Press until it clicks into position.
Page 9
b. To fit the floor head to the Extension Tube telescopic tube, gently insert the telescopic tube into the top of the floor head as shown. Floor Head The Floor Brush is ideal for cleaning on hard floors. The Combination Floor Tool is ideal for cleaning on carpets and hard floors...
Maintenance Emptying the dust canister Always operate the cleaner with the dust compartment correctly installed. Ensure the filter is correctly installed when the cleaner is in use to prevent any damage to the cleaner. Gently remove the dust canister by pulling in an upwards direction.
Page 11
Cleaning and changing the filter Ensure the cleaner is not connected to the mains power when performing any maintenance duties. • The air inlet filter should be cleaned at least twice a year or when it appears dirty. • The HEPA air inlet filter should be cleaned when it appears dirty. •...
Conditions of warranty Your Hoover cleaner, in the case of domestic use, has a two cleaner is at the sole discretion of Hoover Floorcare. If Hoover Floorcare year parts and labour warranty against product defects decide to repair or replace the cleaner, it will do so at its own cost.