Add System Memory - Panasonic AY-NE2000 Installation Manual

ADD SYSTEM MEMORY

The system memory should be as follows:
Type 168-pin DIMM type
Memory Type SDRAM
Memory Capacity 32MB, 64MB, 128MB
Power Voltage 3.3V
Operational Speed More than 100MHz
ECC Not required
SPC Not required
There are two types of factory setting of memory configura-
tion depending on the production period. The configuration
of additional memory varies. Before installing additional
system memory, you should check which type of memory
you have.
The two types of memory configuration are as follows:
Configuration : 16 pieces of memory in both
sides of the module.
Configuration : 4 pieces of memory in single side
of the module.
VGA Parallel COM2
24
COM1 Mouse Keybd
DIMM Socket
DIMM3,2,1
3 2 1
Memory board installed in DIMM Slot 1
(1) Factory Setup
DIMM1 32MB
DIMM2 not used
DIMM3 not used
Total 32MB
(2) Add 32MB Memory
DIMM1 32MB
DIMM2 32MB
DIMM3 not used
Total 64MB
Note: The memory you add should be the same type
as the original one which includes 16 pieces of
memory in both sides of the module.
Memory board installed in DIMM Slot 2
(1) Factory Setup
DIMM1 not used
DIMM2 32MB
DIMM3 not used
Total 32MB
(2) Add 32MB Memory
DIMM1 not used
DIMM2 32MB
DIMM3 32MB
Total 64MB
Note: The memory you add should be the same type
as the original one which includes 4 pieces of
memory in single side of the module.
64MB, 128MB should be arranged as follows in both
configurations above;
(3) Add 64MB Memory
DIMM1 not used not used
DIMM2 64MB
DIMM3 not used
Total 64MB 128MB
(4) Add 128MB Memory
DIMM1 not used not used
DIMM2 128MB 128MB
DIMM3 not used 128MB
Total 128MB 256MB
32MB
32MB
32MB
96MB
64MB
64MB