Download  Print this page

Advancer Disassembly - Kawasaki KX85 Service Manual

Hide thumbs
Also See for KX85
Brochure - 13 pages
Service manual - 233 pages
Owner's manual - 172 pages

Advertisement

6-16 ENGINE RIGHT SIDE
Clutch Cover and Right Engine Cover
Fit the advancer [A] to the lever shaft [B] as shown.
Align [A] the mark [B] on the lever shaft with the mark
[C] on the right engine cover and insert the shaft into the
cover.
Tighten:
Torque - Lever Shaft Retaining Bolt [D]: 5.2 N·m (0.53
kgf·m, 46 in·lb)
Install the advancer in the right engine cover.

Advancer Disassembly

Hold the bearing puller [A] in a vise, and set the advancer
assembly [B] with the gear upward on the bearing puller.
Screw the rod [C] in and pull out the gear on the shaft. Do
not drop the assembly parts on the floor.
Special Tools - Bearing Puller: 57001-158
Bearing Puller Adaper: 57001-1526 [D]
The advancer assembly consists of the following parts.
Gear [A]
Spring [B]
Collar [C]
Circlip [D]
Ball Bearing [E]
Collar [F]
Holder [G]
Shaft [H]
Ball [I]
Guide [J]
Check the advancer assembly parts for damage.
Any damaged parts should be replaced with new ones.
When assembling, apply molybdenum disulfide grease
between the shaft and inside/outside diameter parts of the
holder, ball bearing and collars.

Advertisement

Table of Contents

   Also See for Kawasaki KX85

This manual is also suitable for:

Kx100Kx85-ii

Comments to this Manuals

Symbols: 0
Latest comments: