Clutch Lever and Cable
Take the clutch cable off the cable holder [A].
Take the clutch cable lower end [B] off the clutch release
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, release shaft oil
seal must be replaced with a new one.
Remove the clutch cable.
Clutch Cable Installation
Run the clutch cable correctly (see Cable, Wire, and Hose
Routing section in the Appendix chapter).
Adjust the clutch cable (see Clutch Operation Inspection
in the Periodic Maintenance chapter).
Install the removed parts (see appropriate chapters).
Clutch Cable Inspection and Lubrication
During a periodic inspection or when the cable has been
removed, inspect and lubricate the cable (see General
Lubrication and Cable Inspection section in the Periodic
ENGINE RIGHT SIDE 6-9