Download  Print this page

Kawasaki VN1700 Assembly Instructions

Tachometer, bar clamp vn1700 nomad; vn1700 classic; vn1700 classic lt.
Hide thumbs
   

Advertisement

Description:
Part-Number:
Before you begin installation, read through the installation instructions and check to be sure all parts are
present.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to complete the
installation. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect
installation.
Parts List
Seq.
Part Number
T.B.D.
1.
2.
99-0605
Tachometer Installation Preparation
Parts Removal
Refer to the Service manual for specific information in removing
the bar clamp components if further instruction is needed.
Remove the two screws holding the headlight assembly and
carefully disconnect the 3-pin connector on the back of the
headlight reflector to remove the headlight, set it aside for now.
Remove the four chrome handlebar clamp caps and bolts and the
two clamps, being careful not to move the handlebars, see side
note.
Install Tachometer
Apply 2-stroke oil to the threads of the clamp bolts. Place the
tachometer onto the handlebar clamp area and reinstall the four
bolts. Make sure the handlebar punch mark aligns with the lower
mating surface of the bar clamp at the rear edge. Tighten the front
clamp bolts first, and then the rear bolts.
Tighten the bolts to 34 Nm (25 Ft-lbs)
o
There will be a small gap at the back of the clamp.
Assembly Instructions
Tachometer, Bar Clamp
K53020-386
Description
Tachometer
Assembly
4" cable ties
Installation Instructions
NOTE:
Model:
Approximate
Assembly Time:
Qty.
Cross-point screwdriver
Small flat blade screwdriver
1
Wire connector crimping pliers
8mm Hex Socket 3/8" drive
Ft.lb. torque wrench
3
(Range minimum: 20 Ft lbs)
Punch mark
aligned with
top surface of
lower clamp
VN1700 Nomad, Classic
and Classic LT
30 min
Tools Required:
NOTICE
It is recommended that you
have an assistant stabilize the
handlebars at this point to
prevent the handlebars from
moving away from the original
position and possibly causing
damage to the fuel tank

Advertisement

Table of Contents

   Summary of Contents for Kawasaki VN1700

  • Page 1 Before you begin installation, read through the installation instructions and check to be sure all parts are present. If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to complete the installation. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect installation.
  • Page 2 Black / Orange Stripe Coil Wire Care and Cleaning: Do not use abrasive cleaners; wash with mild soap and warm water. Please check / adjust all screws in regular intervals. WIRE SCHEMATIC FOR VN1700 TACHOMETER Notes: Insert male bullet connector into double female bullet connector inside headlight shell.

This manual is also suitable for:

K53020-386

Comments to this Manuals

Symbols: 0
Latest comments: