Using the Scan Engine
Point the aiming beam at a bar code. The aiming beam must align
with the bar code for the best results. Holding the terminal between
4-10 inches (10-25 cm) from a bar code is recommended.
1. Select Start > Programs > Demos > Scan Demo.
2. Point the Optimus terminal at the bar code.
3. Project the aiming beam by pressing and holding the SCAN key.
4. Center the aiming beam over the bar code. For optimum perfor-
mance, avoid reflections by scanning the bar code at a slight
angle.
5. When the bar code is successfully decoded the terminal beeps.
The bar code information is entered into the application in use.