Emptying the reservoir during oper-
Once the max. fill level (mark) of the dirt
water reservoir is reached, please empty
the tank.
Turn off the appliance.
Illustration
Pull off the lock of the dirt water reser-
voir and empty the tank.
Close the dirt water reservoir.
Finish up your work / clean
appliance
Turn off the appliance.
Illustration
First, release the attachment with the
pull-off lips and remove it from the suc-
tion head, then release the suction
head and remove.
Clean the suction head and the attach-
ment with the pull-off lips under running
water (do not wash in dishwater).
Illustration
Caution: The basic appliance contains
electrical components. Do not clean this
under running water!
Remove the dirt water reservoir, rotate
the lock and pull out.
Empty the reservoir and rinse with clear
water. Close the reservoir again.
Pull the wipe pad off the spray bottle
and clean under running water. The
wipe pad can be cleaned in a washing
machine; however, do not use fabric
softener.
Let the cleaned appliance dry prior to
assembly.
Charge the battery.
Storing the Appliance
Store the appliance upright in a dry
room.
6 English
ation
Troubleshooting
Spray bottle does not spray
Refill detergent.
Pump mechanism in spray botte defec-
tive, contact dealer.
Machine does not start
Check the charge/operations display:
No signal or slowly blinking signal:
Charge the battery.
With a rapidly blinking signal: Inform
your dealer.
Streaks while cleaning
Clean the pull-off lip.
Reverse the used pull-off lip:
Pull the pull-off lip out of the rubber to-
ward the side. Moisten the rubber lip's
rounded sides with water or detergent.
Reinstall the rubber lip into the holder
with the reverse side first.
Replace the pull-off lip if necessary:
If both edges are worn after the rubber
lip was reversed, you will need to install
a new lip. Replace the rubber lip as de-
scribed above.
Adjust the dosing of cleaning solution.
Water is leaking from the air louvers
Empty the dirt water reservoir (max.
100 ml content).