Kärcher KMR 1250 B Service Manual page 17

KMR 1250 B, LPG, D
Starter Fails to Turn Engine
Checking voltage on starter motor M1
V
Checking voltage on starter solenoid
V
SW
Troubleshooting Information
Check starter M1
– Hold ignition switch in position II.
– If a voltage is present but starter fails to turn,
starter is defective and must be replaced.
Check voltage on starter solenoid
– Hold ignition switch in position II.
– Measure the voltage between solenoid ter-
minal and vehicle ground.
– If the meter fails to indicate a voltage, wiring
must be checked for possible defect.
– If a voltage is present but starter fails to turn,
starter is defective and must be replaced.
Note:
The connecting wiring for the starter sole-
noid are not shown in electrical diagram.
17