Anti-Lock Brake System (Equipped Models)
ABS Hydraulic Unit Installation
Installation is the reverse of removal.
Brake fluid quickly ruins painted plastic surfaces;
any spilled fluid should be completely washed away
When installing the hoses and pipes, avoid sharp bend-
ing, kinking, flatting or twisting, and run the hoses accord-
ing to Cable, Wire, and Hose Routing section in the Ap-
Torque - Brake Hose Banjo Bolts (ABS Hydraulic Unit): 33
N·m (3.4 kgf·m, 24 ft·lb)
Run the lead correctly, and connect the connector se-
Pull the lever [A] forward to connect the ABS hydraulic
unit connector [B].
Bleed the brake line (see Brake Line Bleeding).
Check the brake for good braking power, no brake drag,
and no fluid leakage.
Install the removed parts (see appropriate chapters).
ABS Hydraulic Unit Inspection
Remove the ABS hydraulic unit (see ABS Hydraulic Unit
Visually inspect the ABS hydraulic unit.
Replace the ABS hydraulic unit if any of them are cracked,
or otherwise damaged.
Visually inspect the connector terminals [A].
Replace the ABS hydraulic unit or main harness if either
of the terminals are cracked, bent, or otherwise damaged.
If the ABS hydraulic unit connector is clogged with mud
or dust, blow it off with compressed air.