Separation of Carburetors:
The four carburetors look the same, but
they are slightly different from each other. Notc the
following prior to removal:
o f the air screw and drain plug.
OPresence o f the fuel hose 3-way joint, air vent hose
and connecting pipe.
2. All carburetor parts except the linkage mechanism
and fast idle mechanism can be removed without
separating the carburetors from the mounting plate.
the idle adjusting screw 2s , flat washer
2 9 ,
the rubber caps
from both sides o f the car-
(3 ea), and
remove the top covers
(4) and gaskets Q (4).
.Remove the throttle return spring
3 3 .
A. Throttle Arm Mounting Screws
B. Pulley Mounting Screws
C. Return Spring
.Remove the throttle arm mounting screws
the pulley mounting screws
( 1 1
.Loosen the locknut
and remove the fast idle adjust-
Then remove the fast idle arm mounting
Fast ldle Adjusting Screw
B. Fast ldle Arm
C. Arm Mounting Screw
the screw i and lockwasher 2
the throttle shaft set plate
A. Set Plate
the throttle shaft
out to the right b y turning
the shaft. The carburetor left pulley
2 2 ,
1 0 ,
and fast idle arm
come o f f with the shaft.
A. Throttle Shaft