Download  Print this page

Wheel Coupling, Rear Sprocket Installation Notes - Kawasaki KZ400 Service Manual

Hide thumbs

Advertisement

Table of Contents
126 DISASSEMBLY-CHASSIS
.Using
the bearing driver and driver holder (special
tools) or some other suitable tool, remove the bearing
6
by tapping from the wheel side.
A. Bearing Driver Holder (57001-139)
B. Bearing Driver (57001-288)
Wheel Coupling, Rear Sprocket
Installation Notes:
1. Inspect
195).
L
bearing
tools).
the bearing, and replace if necessary (Pg.
~ b r i c a t e it, and then install it using the wheel
driver and the bearing driver holder (special
A. Bearing Driver Holder (57001-139)
B. Bearing Driver (57001-289)
Replace the grease seal with a new one using the
suitable driver.
Press the seal in until the face of
the seal i s level with the end o f the grease seal hole.
Apply a little grease to the grease seal lip.
Install the rear sprocket with the numbered side
facing out.
After tightening the sprocket nuts to
4.0
kg-m (29 ft-lbs) o f torque, bend the tab portions
o f the double washers over the nuts.
A. Rear Sprocket
C. Sprocket Nut
B. Tooth Number
D. Double Washer
Bearing, Brake Disc Removal:
Do not lay the wheel on the ground with
the disc facing down. This can damage or
warp the disc. Place blocks under the wheel so the disc
does not touch the ground.
.Remove the wheel coupling.
.Pull
out the collar
5
from the disc side.
.Remove
the disc mounting bolts
9
(4),
and take o f f
the disc
E .
.Remove
the grease seal
1 6
using a hook, and remove
the circlip
2.
A. Rear Hub
B. Grease Seal
Bearing Removal
R
rn

Advertisement

Table of Contents

This manual is also suitable for:

Kz500Kz550

Comments to this Manuals

Symbols: 0
Latest comments: