2-62 PERIODIC MAINTENANCE
Apply brake fluid to the outside of the piston, and push it
into the cylinder by hand.
Replace the shaft rubber friction boot [A] and dust boot
Apply a thin coat of PBC (Poly Butyl Cuprysil) grease to
the caliper holder shafts [C] and holder holes [D] (PBC is
a special high temperature, water-resistance grease).
Install the pad spring [A] in the caliper as shown.
Install the pads (see Rear Brake Pad Installation in the
Wipe up any spilled brake fluid on the caliper with wet
Spark Plug Replacement
Stick Coils (see Stick Coil (Ignition Coil together with
Spark Plug Cap) Removal in the Electrical System chap-
Remove the spark plug using the 16 mm (0.63 in.) plug
wrench [A] vertically.
Owner's Tool - Spark Plug Wrench, 16 mm: 92110-1132
Insert new spark plug in the plug hole, and finger-tighten
Using the plug wrench [A] vertically, tighten the plug.
The insulator of the spark plug may break if when
the wrench is inclined during tightening.
Torque - Spark Plugs: 13 N·m (1.3 kgf·m, 113 in·lb)
Install the stick coils securely.
Be sure the stick coils are installed by pulling up it lightly.