Pull the ECU fuse [A] straight out of the fuse box with
needle nose pliers.
If a fuse fails during operation, inspect the electrical sys-
tem to determine the cause, and then replace it with a
new fuse of proper amperage.
Install the fuse box fuses on the original position as spec-
ified on the lid.
Remove the fuse (see Fuse Removal in this chapter).
Inspect the fuse element.
If it is blown out, replace the fuse. Before replacing a
blown fuse, always check the amperage in the affected
circuit. If the amperage is equal to or greater than the
fuse rating, check the wiring and related components for
a short circuit.
Fuse Element [B]
Blown Element [D]
When replacing a fuse, be sure the new fuse
matches the specified fuse rating for that circuit.
Installation of a fuse with a higher rating may cause
damage to wiring and components.
ELECTRICAL SYSTEM 16-101