Meter, Gauge, Indicator Unit
In the HOUR setting mode, press the reset button [C] to
effect the MINUTE setting mode.
The minute display flashes on the display.
Press the mode selector button [A] to set the minute.
In the MINUTE setting mode, press the reset button [C]
to return to the HOUR/MINUTE setting mode.
Press the mode selector button [A] to complete the time
The clock starts counting the seconds a soon as the mode
selector button is pressed.
Indicate the ODO mode.
If the display function does not work and adjust, replace
the meter assembly.
Check that the display [A] [B] change to the mile and °F,
Mile and °C, km and °F, km and °C display each time by
pushing the RESET bottom while MODE bottom pushed
Mile/Km Display can alternate between English and
metric modes (mile and km) in the digital meter. Make
sure that km or mile according to local regulations is
correctly displayed before riding.
Connect the 12 V battery and terminals in the same man-
ner as specified in the "Liquid Crystal Display (LCD) Seg-
The speed equivalent to the input frequency is indicated in
the oscillator [A], if the square wave (illustrated as shown)
would be input into the terminal .
Indicates approximately 60 mph in case the input fre-
quency would be approximately 1 168 Hz.
Indicates approximately 60 km/h in case the input fre-
quency would be approximately 730 Hz.
If the oscillator is not available, the speedometer can be
checked as follows.
Install the meter unit.
Raise the rear wheel off the ground, using the jack.
Turn on the ignition switch.
Rotate the rear wheel by hand.
Check that the speedometer shows the speed.
If the speedometer does not work, check the speed sen-
sor electric source voltage and speed sensor.
The electric source voltage and speed sensor are normal,
replace the meter assembly.
ELECTRICAL SYSTEM 16-67