Install the starter gear [A] and washer [B].
Again, clean the crankshaft tapered portion [C] and dry
Install the alternator rotor [A] while turning [B] it counter-
Install the washer [A].
Confirm the alternator rotor fit or not to the crankshaft
before tightening it with specified torque.
Install the rotor bolt [B] and tighten it with 70 N·m (7.0
kgf·m, 52 ft·lb) of torque.
Remove the rotor bolt.
Check the tightening torque with flywheel puller [C].
If the rotor is not pulled out with 40 N·m (4.1 kgf·m, 30
ft·lb) of drawing torque, it is installed correctly.
If the rotor is pulled out with under 40 N·m (4.1 kgf·m, 30
ft·lb) of drawing torque, clean off any oil dirt or flaw of the
crankshaft and rotor tapered portion, and dry them with
a clean cloth. Then, confirm that it is not pulled out with
Tighten the alternator rotor bolt while holding the alterna-
tor rotor steadily with the flywheel holder.
Special Tool - Flywheel Holder: 57001-1313
Torque - Alternator Rotor Bolt: 110 N·m (11 kgf·m, 81 ft·lb)
Apply a thin coat of molybdenum disulfide grease to the
shaft [A], and install it and starter idle gear [B].
Install the alternator cover (see Alternator Cover Installa-
tion in this chapter).
ELECTRICAL SYSTEM 16-31