Side Stand Removal
Raise the rear wheel off the ground with the stand.
Lower Fairings (see Lower Fairing Removal in this chap-
Fuel Tank (see Fuel Tank Removal in the Fuel System
Disconnect the side stand switch lead connector [A].
Side Stand Switch Bolt [A]
Side Stand Bolt [C]
Side Stand [D]
Switch Bracket Bolts [E]
Side Stand Bracket Bolts [F]
Side Stand Installation
Apply grease to the sliding area [A] of the side stand [B]
and thread of the side stand bolt [C].
Tighten the bolt and lock them with the nut.
Torque - Side Stand Bracket Bolts [D]: 49 N·m (5.0 kgf·m,
Side Stand Bolt: 44 N·m (4.5 kgf·m, 32 ft·lb)
Hook the spring [E] so that face the long spring end up-
Install the spring hook direction as shown.
Install the switch bracket and side stand switch.
Apply a non-permanent locking agent to the thread of the
Torque - Side Stand Switch Bolt [F]: 8.8 N·m (0.90 kgf·m, 78