Remove the ball bearing [A] from each shafts.
Special Tools - Bearing Puller [B]: 57001-135
Bearing Puller Adapter [C]: 57001-317
Discard the bearing.
Transmission Shaft Assembly
Install the ball bearing on the drive shaft [A] with the
groove [B] toward the clutch side using the bearing
Install the ball bearing and collar on the output shaft [C]
using the bearing driver.
Special Tool - Bearing Driver, 32: 57001-382
Apply molybdenum disulfide oil to the sliding surfaces of
the gears and shafts.
Install the gear bushings [A] on the shaft with their holes
Replace any circlips removed with new ones.
Install the circlips [A] so that the opening [B] is aligned
with a spline groove [C].
Check that each gear spins or slides freely on the trans-
mission shafts without binding after assembly.
The drive shaft gears can be recognized by size: the gear
with the smallest diameter is 1st gear, and the largest one
is 6th gear. Be sure that all parts are put back in the cor-
rect sequence and all circlips and washers are properly in
Install the 3rd/4th gear onto the drive shaft with their oil
The output shaft gears can be recognized by size: the
gear with the largest diameter is 1st gear, and the small-
est one is 6th gear. Be sure that all parts are put back
in the correct sequence and all circlips and washers are
properly in place.
Install the 5th and 6th gears onto the output shaft with
their oil holes aligned.