Oil Pan Removal
Engine Oil (Drain, see Engine Oil Change in the Periodic
Exhaust Pipe (see Exhaust Pipe Removal in the Engine
Top End chapter)
Remove the water hose from the oil pan clamp.
Oil Pan Bolts [A]
Oil Pan [B]
Remove the oil screen, oil pipe and oil pressure relief
valve [A] as necessary.
Oil Pan Installation
Clean the oil screen [A].
Install the oil screen so that the crankcase rib [B] fits the
slot of the oil screen.
If the oil pressure relief valve [A] was removed, install it.
Apply a non-permanent locking agent to the threads of
the oil pressure relief valve, and tighten it.
Do not apply too much non-permanent locking
agent to the threads. This may block the oil pas-
Torque - Oil Pressure Relief Valve: 15 N·m (1.5 kgf·m, 11
Install the clamp [A] as shown.
Replace the oil pan gasket with a new one.
Torque - Oil Pan Bolts [C] : 9.8 N·m (1.0 kgf·m, 87 in·lb)
ENGINE LUBRICATION SYSTEM 7-9