Cylinder Head Removal
Drain the coolant (see Coolant Change in the Periodic
Fuel Tank (see Fuel Tank Removal in the Fuel System
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Throttle Body Assembly (see Throttle Body Assembly
Removal in the Fuel System (DFI) chapter)
Exhaust Pipe (see Exhaust Pipe Removal in this chap-
Cylinder Head Cover (see Cylinder Head Cover Re-
moval in this chapter)
Camshaft Position Sensor (see Camshaft Position Sen-
sor Removal in the Electrical System chapter)
Camshafts (see Camshaft Removal in this chapter)
Front Camshaft Chain Guide Bolts [A]
Rear Camshaft Chain Guide Bolt [B]
Right and Left Upper Engine Mounting Bolts (see Engine
Removal in the Engine Removal/Installation chapter)
Remove the M6 cylinder head bolt [A], and then the M9
cylinder head bolts [B].
Take off the cylinder head forward.
Cylinder Head Installation
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
Install a new cylinder head gasket and dowel pins.
Apply molybdenum disulfide oil solution to both sides [A]
of the cylinder head bolt washers.
ENGINE TOP END 5-21