3-112 FUEL SYSTEM (DFI)
Remove the fuel hose [A].
Remove the engine breather hose [B].
Remove the drain hose.
Remove the vacuum switch valve hose [A].
Air Cleaner Housing Installation
Install the vacuum switch valve hose to the air cleaner
Install the air cleaner housing on the throttle body assy.
Torque - Air Cleaner Housing Clamp Bolts: 2.0 N·m (0.20
kgf·m, 18 in·lb)
Air Cleaner Housing Mounting Bolt: 6.9 N·m (0.70
kgf·m, 60 in·lb)
Install the drain and engine breather hoses.
Insert the fuel hose joint [A] straight onto the delivery pipe
until the hose joint clicks.
Push [B] the joint lock [C] until the hose joint clicks.
Push and pull the hose joint back and forth more than two
times and make sure it is locked and doesn't come off.
When the hose joint is correctly installed, it should slide
on the delivery pipe about 5 mm (0.2 in.).
Make sure the hose joint is installed correctly on the
delivery pipe by sliding the joint, or the fuel could
If it dose not slide, reinstall the hose joint.