Table of Contents
Advertisement
IMPORTANT PRECAUTIONS – continued
PRECAUTIONS
Water Supply (Cold Water Only)
•
Water hose must be at least 3/4 inch in
diameter.
•
Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
•
Flow rate can be determined by running
the water for one minute into an empty"
5-gallon container.
ASSEMBLY INSTRUCTIONS
4
Step 1
Attach one adapter bracket to
pressure washer by aligning
holes on adapter bracket with
posts on the pressure washer as
shown. Tighten the two screws.
Step 4
Pull out the locking slide from the right side of
the trigger gun handle, and insert the small
end of the high pressure hose into place. Push
the locking slide back into the trigger gun to
lock the hose in position.
•
The water supply temperature must not
exceed 104°F/40°C.
•
Never use the pressure washer to draw
in water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
•
Always prevent debris from being drawn
into the unit by using a clean water source.
Step 2
Place detergent tank between
adapter brackets as shown.
Attach second adapter
bracket.
Step 3
Attach handle onto top of
adapter brackets. Press down
to lock. Tighten with screws
as shown.
Note: Hose/cord caddy and
trigger gun holder must be
on opposite sides
Hide quick links:
Advertisement
Table of Contents
