Download  Print this page

Power Supply; Operating The Light - Black & Decker Ultrabright LED Spotlight Instruction Manual

Hide thumbs

Advertisement

circuits. So when transporting individual batteries, make sure that the battery
terminals are protected and well insulated from materials that could contact them
and cause a short circuit."
SAVE thESE inStRuctionS
introdUCtion
Congratulations on purchasing your new Black & Decker Work Light. Read this
Instruction Manual and follow the instructions carefully before using your new
work light.
FeatUreS
5
1
2
6
3
7
8
4

Power SUPPly

The unit is powered by three "AA" alkaline dry cell batteries (may be sold
separately). Unscrew the base cover screw (counter-clockwise) and remove the
base cover. Insert batteries as described in compartment, observing the cautions
that follow. Replace and secure the base cover by screwing the base cover screw
clockwise. Do not be over-tighten.
Note:
Use only "AA" alkaline dry cell batteries in this unit.
1. Magnetic base
2. Base cover
3. Base screw
4. Three (3) "AA" alkaline dry
cell batteries (may be sold
separately)
5. Hanging hook
6. 14 ultra bright LEDs
7. Pivot tube
8. Light mode pushbutton (High/
Medium/Off/Flash)
CAUTIONS
• When replacing the "AA" alkaline dry cell batteries: DO NOT mix old and new
batteries. Always insert batteries correctly with regard to polarity (+ and –),
marked on the battery and the equipment. Remove dead batteries immediately and
dispose of per local codes.
• Follow all warnings regarding batteries in the Important Safety Instructions section
of this manual.

oPerating the light

• Position the unit as desired. Press the light mode pushbutton on the front of the
unit.
• Press once for high intensity.
• Press again for medium intensity.
• Press a third time for to turn the light off.
• Press and hold the light mode pushbutton for about five seconds for flashing
LEDs.
adjusting the pivot tube
The pivot tube allows the light to be tilted backward and forward to direct the
illumination upward or downward.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• Do not attempt to "force" the pivot tube beyond its maximum angle.
• The pivot tube was designed to tilt forward and backward only.
• The pivot tube was designed to be used when the unit is hanging or attached to a
surface using its magnetic base. Using it when the unit is placed on a level, non-
metallic surface may cause the light to fall over and sustain damage.
• NEVER attempt to rotate the light tube itself. Always use the pivot tube to adjust
the area of illumination.
Using the hanging hook and magnetic base
The hanging hook and magnetic base allow you to position the light for convenient,
hands-free operation. The hanging hook rotates 360° to direct illumination as
needed.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When light is hung by the hanging hook or attached using the magnetic base, do
not shake the light or object that it is hanging from or attached to. Do not hang
the light from or attach the light to any electrical wires or anything that it is not
secure.

Advertisement

loading

  Related Manuals for Black & Decker Ultrabright LED Spotlight