Table of Contents
Advertisement
IMPORTANT PRECAUTIONS –
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch
in diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
ASSEMBLY INSTRUCTIONS
You will need a standard screw driver OR a Torx T-25 screw driver
3
Step 1
Slide each of the mobile adapter brack-
ets to the pressure washer. Align the pegs and
holes on the brackets. Insert the 4 screws and
tighten as shown.
Step 3
Slide the hose caddy into the handle
slots and snap into place.
continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw
in water contaminated with solvents,
e.g. paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water
source.
Step 2
Slide the handle onto the
mobile adapter brackets as shown,
insert screws and tighten.
Step 4
Slide the spray wand exten-
sion into the gun. Turn the wand collar
clockwise onto the gun threads until
tight.
Hide quick links:
Advertisement
Table of Contents
