Connecting The Slave Renderer To A Lustre Workstation - HP Autodesk Lustrexw8400 Hardware Setup Manual

3 Connecting System Components
To connect a stand-alone tablet, connect the tablet to USB Out 1 on the USB extender.
N :
On Windows-based workstations you may need to restart Windows for the tablet to be
OTE
recognized. On Linux-based workstations, re-starting the Xserver prompts tablet recognition.
C +A
Press
TRL LT

Connecting the Slave Renderer to a Lustre Workstation

The Slave Renderer is available for the Master Station, the Lustre Station, and the Lustre HD
Station, all of which must be running on a Windows-based workstation. The Slave Renderer is
is not available for the Linux-based version of Lustre since it uses Incinerator to obtain real-time
rendering and playback.
Although the Slave Renderer is connected using a network connection, a higher Category 6
grade cable is needed to accommodate the data that is transmitted. For information on
configuring the IP addresses of the network ports that connect the two workstations, see the
Autodesk Lustre 2007 Software Installation Guide for Windows Workstations.
To connect the Slave Renderer to a Windows-based workstation:
Connect the Category 6 crossover cable to the on-board network port at the back of the
1.
Lustre workstation.
2. Connect the other end of the cable to the network port 1 of the Slave Renderer machine.
The Slave Renderer should be connected as shown in the following diagram:
28
+
to start the Xserver.
BACKSPACE