Assigning An Ip Address To The Autodesk Control Surface - HP Autodesk Lustrexw8400 Hardware Setup Manual

N :
The above diagrams represent a Windows-based configuration. Components may differ
OTE
slightly for the Linux configuration but the control surface connections are identical.

Assigning an IP Address to the Autodesk Control Surface

After you have connected the Autodesk control surface, you must assign it an IP address.
To configure the Autodesk control surface on Windows-based workstations:
Click Start | Settings | Network Connections.
1.
N :
You can also access Network Connections from the Control Panel.
OTE
Right-click the port that the control surface switch or panel is connected to and choose
2.
Properties.
3. In the Local Area Connections Properties dialog box, select Internet Protocol (TCP/IP) and
click Properties.
The Internet Protocol (TCP/IP) Properties dialog box opens.
Assigning an IP Address to the Autodesk Control Surface
25