Kärcher G 2600 OR Operator's Manual page 13

TROUBLESHOOTING – continued
• Loose fittings.
- Tighten fittings.
• Missing/worn rubber washer.
- Insert new washer.
• Spray wand not properly attached.
- Slide the spray wand into the gun.
Turn the wand collar clockwise onto
the gun threads until tight.
• Broken o-ring.
- Call Kärcher customer service hotline
and order an o-ring.
• Pump is sucking air.
- Check that hoses and fittings are air
tight. Turn off machine and
purgepump by squeezing trigger gun
until a steady flow of water emerges
through the nozzle.
• Loose fittings.
- Check that all fittings are tight.
• Water seals are damaged or worn.
- Call service center.
• Thermal protection device is
activated.
- Thermal protection device will auto
reset.
• Oil seals are damaged or worn.
Call service center.
WARRANTY USA
WARRANTY CDN
Kärcher Customer Support USA
Kärcher Customer Service CDN
13