Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Kärcher 670M
Summary of Contents for Kärcher 670M
- Page 2 Please read these operating instructions before starting and strictly observe the "Safety Instructions for High Pressure Cleaners (5.951-949)". WARNING • DO NOT USE WITH FLAMMABLE LIQUIDS AND TOXIC CHEMICALS • INJECTION HAZARD: EQUIPMENT CAN CAUSE SERIOUSE INJURY IF THE SPRAY PENETRATES THE SKIN. DO NOT POINT THE GUN AT ANYONE OR ANY PART OF THE BODY.
-
Page 3: Parts List
1 Carrying handle 2 High-pressure hose reel 3 High-pressure outlet 4 Appliance switch (ON/OFF) 5 Connection lead 6 Mains cable rewinding 7 Support leg 8 Water connection with filter 9 Coupling 10 Detergent suction hose with dosing ring 11 Detergent container 12 Spray gun 13 Safety ratchet 14 High-pressure hose... -
Page 4: Mise En Service
Starting Mise en service... -
Page 5: Operation With High Pressure
Operation with high pressure Marche avec haute pression... -
Page 6: Operation With Detergent
A - Operation with Detergent -------------- B - Suction operation A - Marche avec un détergent --------------- B - Mode aspiration... - Page 7 A - Switching Off ------------------------B - Care and maintenance A - Domaine d’application -------- B - Entretien et maintenance...
-
Page 8: Troubleshooting
Starting -Dirt in the feed water could lead to the appliance being damaged. To avoid this risk, we recommend fitting a filter with 3/4" connection . -If you are using an extension cable, it should always be completely unwound from the cable drum and have a sufficient cross-sectional area (10 m = 1,5 mm², 30m = 2,5 mm²). -
Page 9: Remèdes En Cas De Panne
Mise en service -Toute impureté dans l’eau de la conduite d’rrivée peut entraîner la détérioration l’appareil. Nous recommanddons, dans ce cas, d’utiliser un filtre à eau, raccord R 3/4". -Si une rallonge électrique est employée, celle-ci doit toujours être complètement déroulée de son tambour et ses conduc- teurs doivent être de section suffisante (10 m = 1,5 mm... -
Page 10: Technical Data/Circuit Diagram
Technical Data Power connection Voltage (1~60 Hz) ... 120 V Connected load ... 1,5 kW Mains fuse (slow) ... 15 A Protection class ... II Water connection Supply temperature (max.) ... 60 °C Supply rate (min.) ... 600 l/h Supply pressure (max.) ... 12 bar Supply hose ... -
Page 11: Assembly
670 M-PLUS 6.388-216.0 4.063-681.0 6.362-740.0 6.388-216.0 4.071-120.0 5.731-040.0 5.071-115.0 2.883-111.0 6.647-644.0 4.763-977.0 6.414-384.0 6.389-870.0 5.057-054.0 5.321-445.0 2.883-111.0 6.435-425.0 5.321-445.0 6.435-197.0 5.029-842.0 6.303-047.0 6.362-534.0 4.762-270.0 2.880-296.0 4.760-440.0 6.390-463.0 5.037-140.0 4.775-390.0 6.363-031 6.362-498.0 5.332-464.0 09.01.2001...