Abs Disabling Function - Ducati Diavel Carbon ABS Owner's Manual

ABS disabling function

E
This function disables or enables the ABS.
To access the function it is necessary to view the "setting"
menu page 48, using button (1, fig. 14) "▲" or (2, fig. 14)
"▼" select the "ABS" function and press the reset button
(12, fig. 12) to go to next page.
Function state is highlighted on the display (ON in green or
OFF in yellow); Use button (1, fig. 14) "▲" or (2, fig. 14) "▼"
to shift the arrow on the left onto the new setting and
confirm by pressing the reset button (12, fig. 12) for 3
seconds.
After these 3 seconds the system checks whether the
request was actually complied with; during the check the
display will show the message "PLEASE WAIT...".
The new condition will be displayed after check time.
Note
If the disabling request was not met, it is
recommended to repeat the procedure. If the problem
persists, contact your Ducati dealer or Authorised Service
Centre.
To exit the setting function, press the reset button (12, fig.
12) where "EXIT" is highlighted.
84