VIDEO OUT/DC IN/SYNC
(video output/DC power
input/sync signal I/O)
75 Ω termination switch
Be sure to turn off the power before making switch
1 VIDEO OUT/DC IN/SYNC (video output/DC
power input/sync signal I/O) connector (12-pin)
Connect the CCXC-12P05N camera cable to this
connector to receive the +12 V DC power supply and
output the video signal. When a sync signal generator
is connected to this connector, the camera module is
synchronized with the external sync signals (HD/VD
2 Shutter speed/Mode setting DIP switch
Shutter speed (bits 1–4):
Set an appropriate shutter speed. (Factory setting:
Potential accumulation mode (bit 5):
(Factory setting: FRAME)
Restart reset/External trigger shutter mode switch
(Factory setting: Normal)
γ compensation ON/OFF switch (bit 9):
Turn on the switch to enable the γ compensation.
(Factory setting: OFF)
GAIN switch (bit 0):
This switch selects MGC (manual adjustment) or
AGC (automatic adjustment). (Factory setting:
Shutter speed/Mode setting DIP switch
HD/VD signal input/output switch
Manual GAIN (M GAIN) control knob
3 HD/VD signal input/output switch
Set the switch to INT to output HD/VD signals from
the camera module.
Set the switch to EXT to input HD/VD signals from an
external unit. (Factory setting: EXT)
4 Manual GAIN (M GAIN) control knob
If you have selected MGC with the GAIN switch (DIP
switch 2), this knob adjusts the gain. (Factory setting:
twelve o'clock position)
If you have selected FRAME using the Potential
accumulation mode (DIP switch 2), set this knob to
MAX. (This is due to requirement CCD.)
5 75 Ω termination switch
Turn it to OFF when not terminating. (Factory setting:
The rear panel shown above is for the models with the
following serial numbers.
XC-ES50/EI50/ES30/EI30: 200001 or later.
XC-ES51: 100001 or later.
XC-ES50CE/EI50CE/ES30CE/EI30CE: 500001 or
XC-ES51CE: 400001 or later.