Toshiba TOSVERT VF-MB1 Instruction Manual page 97

 How to use the guidance function
Here are the steps to follow to set parameters, using the guidance function. (When the Preset speed guidance
auf = 2)
Operation panel
LED display
action
MODE
Display of parameter
MODE
MODE
MODE
If there is anything you do not understand during this operation, press the MODE key several times to start over
from the step of  display.
 or  is affixed respectively to the first or last parameter in each guidance wizard parameter group.
Displays the operation frequency (output stopped).
(When standard monitor display selection = is set to 0

[output frequency]).
The first basic parameter "History ()" is displayed.

Turn the setting dial to select the guidance function ().

Press the center of the setting dial to display .

Turn the setting dial to change to the purpose-specific guidance

setting value "".
Press the center of the setting dial to display the purpose-specific

guidance parameter group (refer to following table).
After moving to the purpose-specific guidance parameter group, use
* * * *
the setting dial to change the parameters.
 is displayed on completion of the setting of the guidance

parameter group.
↓

Press the MODE key to exit the guidance parameter group.
↓
By pressing the MODE key, you can return to the default monitoring

mode (display of output frequency).
↓


E-3
E6581697
Operation
5
