3.1.10 Removing the switch board
(See Figs.10 to 12)
• Remove the front panel assembly.
(1) Remove the five screws N attaching the front panel assem-
bly. (See Fig.10)
(2) Release the ten joints h and take out the rear cover. (See
Fig.11)
(3) Lift the switch board from the front panel assembly little by
little and take out the switch board. (See Fig.12)
Reference:
The volume knob is removed from the front side simultaneous-
ly.
Note:
When removing the rear cover assembly and switch board, be
careful not to lose the compression spring and comp. spring.
(See Fig.12)
Rear cover
Fig.10
h
Rear cover
h
Fig.11
Compression spring
Front panel assembly
Fig.12
N
h
h
Switch board
Comp. spring
(No.MA232)1-11