Sun Microsystems J4200 System Overview Manual page 63

25 SYSLOG_NOT_ACOK_SPS0
26 SYSLOG_NOT_ACOK_SPS1
27 SYSLOG_FAIL_SPS0
28 SYSLOG_FAIL_SPS1
29 SYSLOG_OK_SPS0
30 SYSLOG_OK_SPS1
31 SYSLOG_PLUGIN_PORT
32 SYSLOG_WDT_TIMEOUT
33 SYSLOG_DIAG_PASS
34 SYSLOG_DIAG_FAIL
35 SYSLOG_PLUGOUT_SIM
36 SYSLOG_PLUGIN_SIM
37 SYSLOG_FAIL_I2C
38 SYSLOG_SYSTEM_HEALTHY
39 SYSLOG_PLUGIN_DISK
40 SYSLOG_FW_DIFF
Power Supply 0 is down.
Power Supply 1 is down.
Power Supply 0 was removed.
Power Supply 1 was removed.
Power Supply 0 was installed.
Power Supply 1 was installed.
SAS port 1 is up.
SIM 1 is disabled due to
timeout.
Completed and passed
diagnostic test.
Completed and failed
diagnostic test.
SIM 1 was removed.
SIM 1 is installed.
Controller 1 has encountered a
failure.
System is back to normal state.
Disk 1 is installed
The two SIM firmware
versions are incompatible.
Chapter 4 Understanding the J4000 Family Event Log
J4400 only. Check the
connection between the
power cord and Power
Supply 0.
J4400 only. Check the
connection between the
power cord and Power
Supply 1.
J4400 only. System is in
degraded mode. Reinstall
Power Supply 0 to ensure
a high degree of fault
tolerance.
J4400 only. System is in
degraded mode. Reinstall
Power Supply 1 to ensure
a high degree of fault
tolerance.
J4400 only.
J4400 only.
Contact Sun Service:
http://www.sun.com/su
pport/contacting
A hardware error
occurred in SIM 1. Please
replace SIM 1 with a new
one immediately.
47