Using The Scan Engine - Honeywell Dolphin 60s Quick Start Manual

Mobile terminal

Hide thumbs Also See for Dolphin 60s:

Table of Contents

Using the Scan Engine

Point the aiming beam at a bar code. The aiming beam must align

with the bar code for the best results. Holding the terminal between

4-10 inches (10-25 cm) from a bar code is recommended.

Note: The touch panel display can be activated by using the stylus

(included with the terminal) or your finger. To activate the

display, open a file, or select a menu, use the tip of the stylus

to tap the touch panel display or gently press the touch panel

with your finger.

1. Tap

> Demos

Note: You may activate the Vibrate option by selecting

> Scan Demo > File > Setup > Vibrate. The device vibrates

each time a bar code is decoded.

2. Point the Dolphin terminal at the bar code.

3. Project the aiming beam by pressing and holding the SCAN key.

4. Center the aiming beam over the bar code. For optimum perfor-

mance, avoid reflections by scanning the bar code at a slight

angle. To decode stacked bar codes (e.g., PDF417), slowly

move the beam up or down over the code.

5. When the bar code is successfully decoded, the terminal LED

flashes green and the terminal beeps. The bar code information

is entered into the application in use.

> Scan Demo

> Demos

Table of Contents