Replacing Fan Trays - HP ProCurve 8100fl Series Installation And Getting Started Manual

Replacing Fan Trays

The Fan Status LEDs on the switch chassis and on each fan try indicate when
one or more fans fail. In this case, simply replace the failed component as soon
as possible.
W A R N I N G
For safety, if you are hot swapping out the fan tray assembly, pull the assembly
out one-inch and allow the fans to stop rotating before pulling it all the way out.
To replace a fan tray:
1. Remove the two screws holding the failed fan tray assembly. (The LED
2. Pull the fan tray assembly out.
3. Install the new fan tray assembly as described on
N o t e
In case your cabling installation does not allow access to the fan tray
assemblies, remove as many cables as necessary in order to access them.
on the fan tray and on the chassis will indicate which one is failed.)
Replacing Hardware
Replacing Fan Trays
page 2-15.
4-3