Installing Your New Recorder; Basic Connections - JVC SR-VS30E Instructions Manual

10
EN

Basic Connections

TV aerial cable
21-pin SCART
connector
RF cable
(provided)
AV1 (L-1)
IN/OUT
ANTENNA
ANTENNA
OUT
IN
ATTENTION:
Your TV must have a 21-pin AV input connector
(SCART) for the connection to the recorder.
Aerial connector
Back of TV
21-pin SCART
cable
(not provided)
Mains power cord
Back of recorder
Mains outlet

INSTALLING YOUR NEW RECORDER

It's essential that your video recorder be properly
connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Check the contents.
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" on page 88.
B
Situate the recorder.
Place the recorder on a stable, horizontal surface.
C
Connect the recorder to TV.
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the recorder.
C Connect the provided RF cable between the
ANTENNA OUT connector on the rear panel of the
recorder and the TV's aerial connector.
D Connect the 21-pin SCART cable between the AV1
(L-1) IN/OUT connector on the rear panel of the
recorder and the TV's 21-pin SCART connector.
The AV1 (L-1) IN/OUT connector accepts and delivers either a
composite signal (regular video signal) or a Y/C signal (a signal
in which the luminance and chrominance signals are
separated). If your TV's 21-pin AV input connector (SCART) is
compatible with the Y/C signal, set "L-1 OUTPUT" to
"S-VIDEO" after the connection and the initial settings are
completed ( pg. 52). You can obtain high-quality S-VHS
pictures. (For connection, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.)
Set your TV to the VIDEO (or AV), Y/C, or RGB mode
according to the type of your TV's SCART connector.
For switching the TV's mode, refer to the instruction manual of
your television.
To obtain high-quality S-VHS pictures, you can also use the
S-VIDEO connection described on page 11.
D
Connect the recorder to mains.
Plug the end of the mains power cord into a mains outlet.
After the connection is completed, perform "Auto Set
Up" on page 12.