Maytag OVER-THE-RANGE MICROWAVE OVEN Installation Instructions Manual page 6

PREPARE HOOD FAN
Your microwave oven is shipped with the blower assembled for room venting.
If wall or roof venting is chosen, it is necessary for you to change vent blower
to the appropriate orientation for the chosen venting system.
The mounting plate comes attached to the back of microwave oven. Remove
and save the two screws from the mounting plate. Remove the mounting
plate.
ROOF VENTING
• Remove the 6 screws that attach frame bracket to top of microwave oven.
Carefully slide hood fan out of the microwave oven. Rotate hood fan so that
exhaust ports of hood fan face the top of microwave oven. Slide hood fan
back into microwave oven as far as it will go. Check that exhaust ports face
the top of microwave oven. The wires will extend far enough to allow you
to adjust hood fan.
• Reattach frame bracket with 6 screws.
• Check that damper assembly moves freely before you insert it into frame
bracket. Slide and insert damper assembly into frame bracket as shown.
6