Brother S-7200A Instruction Manual page 46

Error code
Err 4
Err 5
Err 8
Err 13
Err 100
(GrEASEUP)
Err 101
(diP SW4)
If an error code that is not listed above appears, contact the place of purchase.
Is the motor connector disconnected from the
control box?
Insert the connector securely.
Has the machine locked up?
Turn off the power and then turn the machine pulley by hand and check that it
turns easily.
Is the machine connector inside the control
box disconnected?
Insert the connector securely.
the
Is machine head tilted back?
Return the machine head to its normal position.
This appears on the display when the sewing machine has been operating
continuously for 3 minutes or more.
Turn the power switch off and then back on again, and then operate the
sewing machine normally.
the
Is treadle unit connector inside the control
box disconnected?
Insert the connector securely.
This appears on the display when the sewing machine has continued to be used for
a certain period after the "GREASEUP" notification appears without the grease
being applied (without the reset procedure being carried out).
Apply grease and then carry out the reset procedure.
Is DIP switch No.4 inside the control box set
to ON?
Set DIP switch No.4 to OFF.
Possible cause
S-7200A
10. TROUBLESHOOTING
Page
11
2202M
10*
2203M
*
2204M
33*
*
2205M
40