Replacing The Mouse - Lenovo 3000 H Series User Manual

Replacing the mouse

Attention
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://consumersupport.lenovo.com
To replace the mouse:
1. Before removing any media (diskettes, CDs, or memory cards) from the drives,
shut down your operating system, and turn off all attached devices and the
computer.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse. Refer to "Locating connectors on the
front of the computer" and "Locating connectors on the rear of the computer".
Note: Your mouse might be connected to the standard mouse connector
at the rear of the computer or to a USB connector
of the computer.
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the "Completing the installation."
0
Hardware Replacement Guide
at either the front or rear