Service Messages; Service Utilities - Martin MAC 2000 Wash XB User Manual

Temperature
→
      
Software version
→
     
briefly at startup.
DMX
   
The

Service messages

The Service LED on the control panel lights under conditions that require fixture service, and there is a
message describing the service required. To display the message, select
item is available only when the LED is lit. There are two service messages.
            
life for the Osram HTI 1500 W/D7/60 lamp. Do not exceed the average life of the lamp by more than 10%.
                
is typically caused by trying to operate the fixture in ambient temperatures above 40° C (104° F), dirty air
filters, fans, or air vents, or a defective fan.

Service utilities

Important! Enter must be held for several seconds to access the utilities menu.
Test sequences
   
provides a general test of all effects that can be run without a controller.
routines for circuit board testing that are for service use only.
Feedback toggles
An on-the-fly position correction system monitors the color wheels. If a position error is detected, the shutter
closes while the effect resets. This feature can be disabled by turning effects feedback (
off.
The automatic pan/tilt position correction system may be temporarily turned off under
off setting, however, is not saved and the system will be re-enabled the next time the fixture starts. If the
system cannot correct the pan/tilt position within 10 seconds, feedback is automatically disabled.
Adjustment
The adjustment menu (
used by Martin service technicians.
Calibration
The calibration menu (
mechanical reset or home positions. This allows you to fine tune optical alignment and achieve uniform
performance between fixtures. Dimmer and zoom are calibrated to defined points. The other effects are
calibrated relative to an arbitrary reference fixture.
Default offset settings may be restored by selecting default offsets (
Calibrating effects
1 Apply power and strike the lamp.
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed software. The software version is also displayed
menu shows the DMX start code (
is displayed when the lamp counter exceeds 750 hours, which is the rated average
is displayed when the head temperature exceeds safe levels. Overheating
→
      
→
      
) provides utilities to define offsets in software that are relative to the
   
) and DMX values received for each effect.
) provides manual control for making mechanical adjustments and is
Control panel
   
in the main menu. This
→
       
   
→
   
→
       
).
provides
→
   
)
   
. The
15