Ac Power; Power Supply; Fuses; Power Connection - Martin MAC 2000 Wash XB User Manual

AC power

Warning! For protection from electric shock, the MAC 2000 Wash XB must be grounded (earthed).
The AC power supply must have both current overload and ground fault (earth leakage) protection.
Do not connect the MAC 2000 Wash XB to power that is outside the voltage range specified in this
manual and marked on the product.

Power supply

The MAC 2000 Wash XB can be operated on 200 - 240 V nominal AC power. It has an auto-ranging power
supply that adjusts automatically to match AC voltage within this range and to match 50 or 60 Hz power.

Fuses

The MAC 2000 Wash XB is supplied with two 15 A main fuses installed in the fuseholders near the power
switch.

Power connection

Important! Connect the MAC 2000 Wash XB directly to AC power. Do not connect it to a
dimmer system; doing so may damage the fixture.
You may need to install a power plug that is suitable for your region on the power cable. A 3-prong
grounding-type plug must be installed following the plug manufacturer's instructions. The table below shows
some possible pin identification schemes; if the pins are not clearly identified, or if you have any doubts
about proper installation, consult a qualified electrician.
Wire Color
brown
blue
yellow/green
To apply power, set the power switch on the base to the "I" position.

Reduced power function

The MAC 2000 Wash XB has an automatic power reduction function that reduces power to the lamp to
1200 W if the shutter/dimmer is closed for more than 10 seconds. This feature gives more efficient use of
power, reduces heat and reduces the overall noise emission of the fixture.
10
Pin Symbol
live L
neutral N
ground or
Table 1: Power plug connections
MAC 2000 Wash XB
Screw (US)
yellow or brass
silver
green